Search - 1/32 Douglas A-4 Skyhawk

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

..

..

..

Contains a new, accurate engine compressor face clearly visible through the kit intakes and new engine rear. The kit part does not capture the look well. Also included are a new turbine face and complete jet exhaust pipe with detailed nozzle. All parts are 3D printed. Designed for all Trumpeter A-4 ..

..

..

..

..

The Aero 1D 300 gallon tanks were widely used, and were carried in this configuration by all variants of the Skyhawk as well as the F4D Skyray. This set consists of a pair of highly accurate and detailed 3D printed droptanks, complete with separate shackles for mounting to pylons.Drop tanks are prin..

Contains a pair of detailed 3D printed 20mm Colt cannon barrels with muzzle brakes compete with accurately placed and sized vent holes. Barrels are deeply drilled out. For most A-4C and later Skyhawk kits, with the exception of IAF aircraft, which are fitted with different model cannon. A very simpl..

Total : 3 Resin PartsESCAPAC IA-1 Ejection seat for A-4E/F SkyhawkDetailed seatbelts,Total 3 resin parts..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..