Model Cars

This battery cable was designed to be used with Detail Master's Battery Hardware Kit-DM-2340. This photoetched part includes terminals and hold down brackets. Battery Cable is available in Black, Red and Blue...

This battery cable was designed to be used with Detail Master's Battery Hardware Kit-DM-2340. This photoetched part includes terminals and hold down brackets. Battery Cable is available in Black, Red and Blue...

These are larger then actual size (Billet Aluminum)..

Add these billet beauties to your next Holly Carb engine and take your model to the next level of realism! These Holly V-Stacks are turned solid aluminum, no seams to worry about...

1 Billet Distributor. 1pc white wire, 1 shaft, 1 etch pc. This distributor is designed for 4,6,or 8 cylinder..

..

1 Billet Distributor. 1pc grey wire, 1 shaft, 1 etch pc. This distributor is designed for 4,6,or 8 cylinder..

..

..

..

..

..

..

size of rim: 1.8cm..

This is an upgrade parts set for increasing details like the headlight rim and other locations. For MFH's "1/12 scale 250GTO" use only.- For increasing details to parts like Light Rim, Mirror, Meter Rim, the Belt connectors, emblem base. Made of brass in form of photo etch sheet.- Use a solde..

..

Water-slide Decals: Instruction: 1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them. 2. Cut out the decal you need (do it on cutting mat) 3. Grab the..

(Type: model figures) This is a resin model kit, which comes unpainted. So model paints and other basic modelling tools are additionally required.*NOTE: This model kit is NOT recommended for small children without parental supervision...

Type: water-slide decalsHow to apply water-slide decals:1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.2. Cut out the decal you need (do it on cutting m..

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

NOTE: This kit only includes one unpainted resin figure...

NOTE: This kit only includes one unpainted resin figure...

NOTE: This kit only includes one unpainted resin figure...

NOTE: This kit only includes one unpainted resin figure...