Model Planes

..

..

..

..

..

This is a non-IRST chin (radome) pod for early F-4B's, specifically for the Tamiya kit. This pod/fairing was fitted to early F-4B's before and after the short "era" of the IRST system. While in development during the F4H /F4H-1 phase, the first regular F-4B off the production line were not yet fitte..

..

..

This is an upgrade set for Zoukei Mura Phantoms. As per the kit, the stabilators can only be mounted in one (or two) position(s). With this set, you can set the stabilators in any position of your choice and improve the detail on the stabilator pivot cover plates as well. Also included are the reinf..

Stabilator for all types of F-4 Phantom that use the slotted stab. For both the Hasegawa and Academy kits. Includes separate PE pivot cover plates and stiffener "fishplates" (for Air Force variants). The stabs can be used as a drop fit replacement for the kit parts or, with some work on the kit plas..

F-4 Phantom outer pylons, Air Force type, 1:48, designed for the Zoukei Mura line of kits. The pylons have the correct outboard angle built in and come with separate sway brace pins so stores can be mounted at correct angles, either canted in line with the pylon or perpendicular to the ground...

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

Coloured photo-etched set..

This is a set of aft fuselage half parts that correct the shape error on the engine shoulders of the Zoukei Mura short nose Phantoms. in addition to the re-shaped geometry, some surface detail has been improved. Please note that this is not a drop-fit replacement set. Cutting of the fuselage is requ..

F-4 Phantom C/L pylon, 1:48, for the Zoukei Mura line of kits. The pylon fit on and into the detail moulded onto the ZM lower wing surface. It comes with two sets of separate pins - one for the larger stabiliser pins and the smaller sway brace pins that connect to the stores to be mounted...

Detail parts for the inner canopies on F-4 Phantoms. The set comprises of resin and PE parts for windscreen, forward-, centre- and rear canopies and includes canopy actuator jacks, safety uplocks (optional installation), detailed downlocks, forward and rear compasses and various detail parts for the..

Detail parts for the inner canopies on F-4 Phantoms. The set comprises of resin and PE parts for windscreen, forward-, centre- and rear canopies and includes canopy actuator jacks, safety uplocks (optional installation), detailed downlocks, forward and rear compasses and various detail parts for the..

Corrected A/C air intakes for Academy's F-4 Phantom series (F-4B, C and D so far). Drop fit resin replacement. All it takes is a little superglue and a swipe of filler to blend it in...

Decals for F-15E that took part in the operation Odyssey Dawn, Libya 2011. Features two aircraft, 97-0219 and 01-2003. Markings include full crew names that were re-applied after the operation, full contemporary stencils and landing gear placards. The set comes with paint masks for insignia, ID mark..

..

Hollowed, thin-walled resin part to detail the open-ended Jet Fuel Starter (JFS) exhaust tubing as found on modern Eagles, such as the F-15C and F-15E Strike Eagle. A small part that adds detail and interest to this area and brings it up to date on all 1:48 F-15 kits...