AOA Decals 32-007 1/32 Bronco Airframe Stencils/Decals No.2 for USAF OV-10A Broncos (High-Viz)

Note: This set does NOT include aircraft kit.

This sheet provides complete OV-10A Bronco airframe stencils for one aircraft in the original USAF blue-grey FAC camouflage scheme.

Optional one piece wing walkway decal.

Multiple styles of various common markings provided:
- Two variations of PROPELLER warnings
- Three variations of propeller blade tip markings
- Five variations of center fuselage propellor warnings
- Three variations of exhaust hiding areas
- Three variations of the DANGER ejection seat triangles
- Five variations of ARMAMENT info panel

The set includes the correct number of fuel tank markings (5) -
the Kitty Hawk kit represents only the four wing tanks.

In addition to the standard airframe stenciling, the sheet also includes tire slip markings, centerline 150gal fuel tank NO STEP stencils, LW-3B ejection seat markings, and full sponson stenciling.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.