Barracuda BC-32010 1/32 P-51D Mustang Cockpit Stencils and Placards

This sheet provides a complete set of stencils and placards for the cockpit of the P-51D. Over 100 tiny decals recreate the extensive markings found in the cockpit, from the North American Data Plates down to the tiny PULL marking on the droptank release handle. Instrument faces are not included, but everything else is. Even the battery and radios behind the seat bulkhead are covered in this set. Most stencils are readable and accurately recreate the real markings. A simple but spectacular upgrade for the Mustang's large and highly visible cockpit. Designed for the Tamiya kit, but will work with just about any 1/32nd scale P-51D.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.