Print Scale 72-039 1/72 North American P-51D Mustang Decals

Type: water-slide decals

1. P-51D ?Iron Ass? QP-X 44-11661 Lt Col Jack J. Oberhansly 334th FS / 4th FG. 1943-1944

2. P-51D-5-NA KI-S 13859 Lt. Walter H. Moon Mullins of 55th FS / 20th FG.1944

3. P-51D-15-NA coded PI-J 44-15025 Lt. James A. Hickey of 360th FS /356th FG. Red rudder indentified 360th FS

4. P-51D-20-NA ?Big Dick? coded MX-U 44-64147 Col. Richard A. Dick Hewitt of 78th FG from March 1945 the CO of 82nd FS.

5. P-51D coded QP-L 42-106924 Lt. Ralph ?Kid? Hofer?s

6. Maj. Howard D "Deacon" Hively, Athens, OH. 334th Fighter Squadron, ex 71 "Eagle" Squadron. P-51B 43-6898 QP-J "The Deacon".

7. P-51D-20-NA QP-W 44-72155 Lt.Ralph H. Buchanan (Buck) ,Los Angeles, California. To 334th FS 27/7/44 until end of war. 1945

8. P-51D-20-NA (NA.122) 44-63819 KEEP SMILIN, flown by Charles Nelson,
402nd FS/370thFG, Ninth Air Force

9.P-51D 44-14570 WD-D "Thunderbird" Capt. Ted E Lines,
Mesa, AZ. 335th Fighter Squadron.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.