Uschi 1011 Dark Wood Grain Planking Decals for 1/35-1/48 Floor, Vehicles, Aircrafts...(2 sheets)

Plank width on WGP-2 Dark Planking: One sheet 5mm and one sheet 2-3mm
These are great for flooring, wooden crates and boxes and that sort of things in the 35th scale. It also can be used on aircrafts since these are designed to meet the average dimensions of 48th scale plywood-plank-wrapping and generic planking. In case you find it being too wide, you may trim it with a single cut.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.