Print Scale 72-342 Decals for 1/72 Sopwith Camel Part.2

1. F.1 Camel. Unit: 11 Escadrille. Pilot - Adj. Leon Cremers. Circa 1918.
2. F.1 Camel. Unit: 9 Escadrille. Serial: Sc7. This Camel was used by the Belgian ace Jan Olieslagers, 9th fighter escadrille, Belgian air service, at the end of the first world war.
3. 2F.1 Camel Serial: N6616. Delivered in 1919, the aircraft was obtained from HMS Vindictive and served alongside other British aircraft like the Avro 504K and DH.9.
4. Sopwith 2F.1 Camel Serial: 9 (ex N8187). Latvian Air Regiment, circa 1919-20. Serial No.9 in White. The old British serial N8187 is in Black on White.
5. Sopwith F.1 Camel. Unit: 7.Eskadra Mysliwska "Tadeusz Kosciuszko". Serial: F5234. This a/c operated in Lwow from October 1920. The aircraft was destroyed during a forced landing on 1st August 1921 piloted by Maj.Ludomil Rajski. This Sopwith F.1 Camel was one of 20 ex-RAF Camels supplied to Poland and served with Eskadra 'Tadeusz Kosciuszko' from Lwow against the Red Russians in 1920.
6. F.1 Camel. Unit: 34th RAO. Serial: unknown. Pilot - P.Karpukhin. Summer 1920.

Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.